How To Program Control Events On A DWA-S Sonachron Program Timer

The DWA-S Sonachron Program Timer must be programmed with the date, the time, security code and events for bell ringing or as a controller. After the unit has been switched to an ON/OFF Controller, to program control events:

1. If a security code was set, enter the Security Code. The display should read SELECT FUNCTION.
2. Press RUN.
3. Press PGRM EVENTS. The display should show CONTROL: 12:00AM. If the display shows SIGNAL: 12:00AM, the operation of the unit must be changed.
4. Press FAST FWD or SLOW FWD to set the time of the event.
5. Select the Days of the Week.
6. Select the next time.
7. Select the Days of the Week.
8. Repeat the process of setting the time and days of the week for all events.
9. Press RUN when all events are programmed.
10. Press PGRM REVIEW to review the events programmed.
11. Erase any events as needed.

The DWA-S Sonachron Program Timer should return to the normal display. ALL lunch and break keys as well as remote switches are inactive when using the unit as an On/Off Controller. For further assistance, contact our Technical Support Department at 404-691-1064.