The 5000E Plus has an Optional 30-Volt Plug-In Relay Board(discontinued) for connecting bells. Scheduled events must be set to signal devices at specified times. The signal duration can be from 1 to 30 seconds. To set up the signal length:
- Remove the top cover.
- Press SELECT. If a password is set, the clock will display 99 99.
- Enter the password. The password is required to access the programming. If it is unknown, the time recorder must be reset. To enter the password:
- Press CHANGE to enter the first two numbers of the password.
- Press SET.
- Press CHANGE to enter the second two numbers of the password.
- Press SET
- Press SELECT to position the Indicator Mark over SIGNAL/BUILT-IN BUZZ.
- For External Length, press CHANGE to select the number of seconds.
- Press SET to save the changes.
- For the Built-In Buzzer, press CHANGE to select the number of seconds.
- Press SET to save the changes.
- Press SET again to exit from the Programming Mode.
When completed, the time recorder should return to the normal display.
Comments
0 comments
Article is closed for comments.