The 5000E Plus can be setup for consecutive numbering. In doing so, an initial number must be set and the print order must be changed to include numbering. To setup the consecutive numbering:
- Remove the top cover.
- Press Select. If a password is set, the time recorder will display 99 99.
- Enter the password. The password is required to access the settings. If it is unknown, the time recorder must be reset. To enter the password:
- Press CHANGE to enter the first two numbers of the password.
- Press SET.
- Press CHANGE to enter the second two numbers of the password.
- Press SET
- Press Select to position the Indicator Mark next to NUMBER.
- Press CHANGE to select the Number Digit up to 8 digits.
- Press SET to save the changes.
- Press CHANGE to choose the Repeat Times. At 0, the digit will continuously print.
- Press SET to save the changes.
- Press CHANGE to select the Reset code.
1 |
sets the reset code to Disabled. |
2 |
sets the reset code to the Initial Number. |
3 |
sets the reset code to Zero. |
- Press SET to save the changes.
- Press SET again to exit from the Programming Mode.
When completed, the time recorder should return to the normal display.
Comments
0 comments
Article is closed for comments.