How To Test the PC600 Relay

The PC600 is equipped with a dry contact relay that allows it to be programmed to signal an external device or to act as an access controller. To test the relay on a PC600:

1. Click on the Admin button on the touchscreen.
2. Enter your admin pin number and press enter.
3. Click the Relay Settings
4. At the bottom of the screen press the Test

If correctly wired the PC600 will fire its relay either signaling the device or allowing access. The relay should also be heard clicking very gently if not connected to any external wiring yet. For further assistance, contact our Technical Support Department at 404-691-1064.